Skip to main content

Metal, Cement Fibre, Plastic Rooves Standards

These are the Metal, cement fibre, plastic rooves Standards

The Metal, Cement Fibre, Plastic Rooves set provides guidance to roofers.

Guidance also includes damp-proofing and flashings, and glass in buildings, especially for skylights.  

Project managers, builders, carpenters, engineers and technicians will also find the guidance invaluable.

Available in the Metal, cement fibre, plastic rooves set.

Name Publisher
AS/NZS 3500.3:2021 Plumbing and drainage, Part 3: Stormwater drainage
Current
Standards Australia/Standards New Zealand
Sets out the requirements for materials, design, installation and testing of roof drainage systems, surface drainage systems and subsoil drainage systems to a point of connection.
AS/NZS 3500.4:2021 Plumbing and drainage, Part 4: Heated water services
Current
Standards Australia/Standards New Zealand
Sets out the requirements for the design, installation and commissioning of heated water services using drinking water or rainwater or a combination thereof; includes aspects of the installation from, and including, the valve(s) on the cold water inlet to any cold water storage tank or water heater and the downstream fixtures and fittings; applies to new installations as well as alterations, additions and repairs to existing installations.
AS 1562.1:2018 Design and installation of metal roof and wall cladding, Part 1: Metal
Current
Standards Australia
This Standard sets out requirements for the design and installation of self-supporting metal roof and wall cladding, subjected to out-of-plane external actions and in-plane thermally induced actions, permanent actions on walls and steep roofs and frictional drag of wind and snow actions.
SA HB 39:2015 Installation code for metal roof and wall cladding
Current
Standards Australia
Provides information and guidelines on the selection, performance and installation of metal roofing and wall cladding.
AS 4440-2004 Installation of nailplated timber roof trusses
Current
Standards Australia
Specifies basic requirements for the bracing, connection and installation of nailplated timber roof trusses. Requirements are given for supporting structures, roof truss installation, roof bracing, truss connection and overhangs.
AS/NZS 2904:1995 Damp-proof courses and flashings
Current
Standards Australia/Standards New Zealand
Specifies the requirements for damp-proof course and flashing materials of the sheet membrane, strip and collar type for use in building construction.
AS/NZS 1562.2:1999 Design and installation of sheet roof and wall cladding, Part 2: Corrugated fibre-reinforced cement
Current
Standards Australia/Standards New Zealand
Sets out requirements for the materials, design and installation of corrugated fibre-reinforced cement roof and wall cladding; provides test procedures for the determination of resistance to wind force; appendix gives advice on the provision of roof ventilation.
AS 1562.3-2006 Design and installation of sheet roof and wall cladding, Part 3: Plastic
Current
Standards Australia
Specifies procedures for the design and installation of plastic roof and wall cladding materials for walls and roofs.
AS 3999:2015 Bulk thermal insulation - Installation
Current
Standards Australia
Sets out requirements on installing insulation in both new dwellings during construction and the retrofitting of insulation in existing buildings.
AS 4654.2-2012 Waterproofing membranes for external above-ground use, Part 2: Design and installation
Pending Revision
Standards Australia
Sets out a consistent and reliable approach to the design and installation of external waterproofing membrane systems.
SA HB 39:2015 Amd 1:2021 Installation code for metal roof and wall cladding
Current
Standards Australia
SA HB 39:2015 is amended as follows.
AS 1288:2021 Glass in buildings - Selection and installation
Current
Standards Australia
Sets out procedures for the selection and installation of glass in buildings, subject to wind loading, human impact, and special applications. Glass strength is specified, based on the tensile stresses on the surface of the glass.